New Holland: CX8080 Tier 4 Combine
DELUXE CAB
General:Curved, tinted glass, with front sun visor Left-hand entry door with curved glass Large, rear window for grain tank view (Tilt open) Breakaway exterior, electric adjust, left and right heated deluxe rearview mirrors (1) Center dome light, (1) Right-hand console light Cab exit delay lighting Telescopic steering column with dual pivots One full coverage dual arm windshield wiper with delay Windshield washer Fore/aft adjustable right console, floats with seat Velour fabric air-suspension operator’s seat with auto height adjust, lumbar and back rest extension Velour fabric padded instructional seat with storage compartment Operator and instructional seat belts Beverage holder, ashtray and lighter Operator ladder with flexible lower step and forward storage position to clear uncut crop and transport Cool box Automatic temperature control Audible alarms for shaft speed monitor system and grain tank 3/4 and full Auxiliary power outlets (1) 12-volt single pin connector (2) 12-volt power outlets Coat hook Metal reinforced mounting surface with electric wiring for business band radios Pre-wired electronic equipment port(s) Radio-ready with AM/FM antenna and standard D40 ISO connectors Business band antenna ready Service tool connection Right Console Dedicated controls for: Separator clutch Feeder clutch Feeder reverse (backlit) Auto/manual reel speed control (backlit) Harvest condition 1 and 2 control (backlit) Hydraulic lockout control for roading transport (backlit) Threshing cylinder speed Ground drive speed range Throttle (backlit) Park brake (backlit) Fan speed Concave position Multifunction Handle (MFH): Adjustable position handgrip Forward/reverse propulsion control with lockout Feeder raise/lower, header tilt, reel raise/lower, reel fore/aft, reel speed Header position resume Unloading auger swing and engagement Feeder forward/reverse direction Header/feeder emergency stop IntelliView IV Capabilities: 10.4″ diagonal color touch screen interface USB memory stick for data collection On the go mapping Fully functional with IntelliSteer Auto Guidance and Yield Mapping Video Input (reference DIA section for Camera Kit) Easily moved between Combine, T7000, T8000, And T9000 tractors Controls NH air carts and PT sprayers Backlit display Engine status/warnings Engine load monitor Machine operation status/warnings Hydraulic oil status/warnings Crop presets for machine settings with additional programmable settings Grain savings monitor Tailings monitor Header control settings Drum speed Fan speed Concave position Service intervals Machine configuration and calibration Header Recognition Diagnostics Trip computer Calibration wizard for yield/moisture Bargraph gauges: Fuel level, Engine coolant temp Status indicator lights integrated in IntelliView IV display: Grain tank 3/4 and full, Unload auger out, Unload auger engaged, Park brake engaged Shaft speed monitoring integrated into the IntelliView IV display: Feeder, Drum, Cleaning fan, Tailings, Clean grain elevator, Straw Walker, Residue chopper In-Cab Storage Areas: Drawer under operator’s seat Under instructional seat Under right armrest Behind operator’s seat
INTELLISTEER™ AUTOGUIDANCE PACKS:
EACH PACK INCLUDES THE COMPONENTS TO
RIGHT CONSOLE:
Dedicated controls for: Separator clutch Feeder clutch Feeder reverse (backlit) Auto/manual reel speed control (backlit) Harvest condition 1 and 2 control (backlit) Hydraulic lockout control for roading transport (backlit) Drum speed Ground drive speed range Throttle (backlit) Park brake (backlit) Fan speed Concave position Sieve position
FEEDER
Fixed speed feeder drive Modulatedhydraulically activated clutch with 2-band belt drive Single lever, head quick-attach system Bolt-in replaceable floor sections Feeder face fore and aft pitch adjustment with position indicator (2) 2.75 in. (70 mm) diameter lift cylinders Hydraulic reverser with forward/reverse rocking capability Mechanical stone trap Floating front drum with multi-position height adjustment Undershot-serrated slat feeder chain Four-strand (CA557) feeder chain with chrome plated pins and high strength bolted “S” slats Poly feeder chain wear strips Feeder safety latch Terrain Tracer™ Header Lateral Tilt
THRESHING/SEPARATING
Threshing Cylinder62 in. (157 cm) wide/29.5 in.(76 cm) diameter with spike tines spaced 2- 3/16 in. (56mm) apart Beater 19 in. (48 cm) diameter, 8-paddle, 1 to 1 speed ratio with threshing cylinder Rotary Separator 28 in. (71 cm) diameter, 12-paddle, 2- speed with grate StrawFlow Beater 12.5 in. (32 cm) diameter, 4-paddle Heavy duty Concave Strawwalkers 6 with (4) steps each
COMPONENTS INCLUDE:
NAV II controller USB memory stick NAV II controller mount GPS receiver Desktop software Yield and moisture sensors
MULTIFUNCTION HANDLE (MFH):
Adjustable position handgrip Forward/reverse propulsion control with lockout Feeder raise/lower, header tilt, reel raise/lower, reel fore/aft, reel speed Header position resume Unloading auger swing and engagement Feeder forward/reverse direction Header/feeder unloader emergency stop
INTELLIVIEW™ IV CAPABILITIES:
10.4″ diagonal color touch screen interface USB memory stick for data collection On the go yield maps Fully functional with IntelliSteer AutoGuidance and Yield Mapping Video Input (reference DIA section for Camera Kit) Easily moved between Combine, T7, T8, T9 tractors Controls NH air carts and PT sprayers Backlit display Engine status/warnings Engine load monitor Machine operation status/warnings Hydraulic oil status/warnings Crop presets for machine settings with additional programmable settings (ACS) Automatic Crop Settings Grain savings monitor Tailings monitor Header control settings Drum speed Fan speed Concave position Service intervals Machine configuration and calibration Header recognition Diagnostics Trip computer Bargraph gauges: Fuel level, Engine coolant temp, Diesel Exhaust Fluid (DEF)
CHOOSE ONE OF TWO PACKS:
CLEANING
Counter-reciprocating self-levelingcleaning system (SLS) Active grain pan system Adjustable closz slat precleaner sieve — 2,207 sq. in. (1.42 sq. meter) Remote adjustable sieves upper and closz slat lower with opening indicator — 7,768 sq. in. (5.1 sq. meter) cleaning area Full width grain savings sensor Full width 26 in. (65.8 cm) diameter variable speed fan with full width air intake and designated outlet to presieve Small speed cleaning fan slow speed kit Dual Re-thresher with both smooth and lugged cover plates Tailings volume sensor Clean-out door for tailings cross auger Slow speed fan
GRAIN HANDLING
Grain tank capacity CR8070: 285 bu.(10,043 Liters) Grain tank covers with in-cab remote control opening and closing Grain tank front window Operator deck grain tank sample access Adjustable grain tank 3/4 and full sensors (2) (1) for early warning and (1) for full bin Ground level clean grain elevator chain adjustment Overhead turrent style unloading system with 3.2 bu/sec (113 liters/sec) unloading rate Modulated hydraulic wet clutch unloading auger drive with brake Electrohydraulic controlled unloading auger swing Adjustable metering gates for grain tank cross augers 18 ft. (5.5 m) Unloading auger with spill saver, with drop down discharge “Clean-out” door for: Clean grain elevator Grain tank cross augers (doors on each end) Vertical unloading auger Abrasive wear cross augers,elevator and bubble up auger
AUTOGUIDE 262 HP/XP COVERS
Uses NH262 GPS receiver with HP/XP DGPS signal. Customer may upgrade NH262 signal to RTK correction via Trimble website along with purchase of RTK radio from New Holland Parts. (Upgraded signal not available from factory.)
IN-CAB STORAGE AREAS:
Drawer under operator’s seat Under instructional seat Under right armrest Behind operator’s seat
AUTOGUIDE 262 HP/XP EXTENSIONS
Uses NH262 GPS receiver with HP/XP DGPS signal. Customer may upgrade NH262 signal to RTK correction via Trimble website along with purchase of RTK radio from New Holland Parts. (Upgraded signal not available from factory.)
RESIDUE HANDLING
Straw hood mounted 2-speed, 4-rowstraw chopper with swinging knives Straight cut knifes installed throughout chopper Hydraulic driven dual chaff blowers
PRECISION FARMING SYSTEMS
Yield and moisture sensors STDUtilizes IntelliView™ IV color display Intellisteer™ Ready autoguidance GPS Steering NH372 Antenna Receiver Omnistar HP/XP/GLONASS version Antenna cable, antenna mounting plate, steering sensors, hydraulic valve, manual override sensor Navigation controller
GROUND DRIVE
Electric shift 4-speed gearboxHydrostatic drive with 130 cc pump and 130 cc motor 19 mph (30 kph) maximum road speed Backup alarm
BRAKES
Manual dual caliper disc service brakesElectrohydraulically released, spring- applied park brake
CHASSIS
Large, hinged, double-walled formedmetal trim panels with gas struts Chassis tow points and shipping tie- down points Toolbox, ground level (2) Fire extinguisher mounting locations Service platforms on both sides of chassis Minimum grease points with extension lube lines for easy access
HYDRAULICS
Closed-center load-sensing primarysystem with maximum 30 gpm (114 Lpm) piston pump Open center secondary system with 10.5 gpm (39 Lpm) gear pump (2) Hydraulic filters Wet clutches to engage main threshing and unloading system Electrohydraulic controls for: Feeder raise/lower, feeder reverser, unloading auger swing, unloading auger engage, reel raise and lower, reel fore and aft, header lateral tilt, emergency shutdown of header/feeder (controlled from the multifunction handle). Thresher engage, header/feeder engage. Park brake actuation Single lever multi-coupler for header hydraulic connection Hydraulic accumulator for ride control
ELECTRICAL
CAN Data Bus serial communicationssystem (2) 12-volt batteries, 825 cca each Ground level battery storage 190 amp alternator (12-volt system) Full capability electrical system with (3) CCMs modules Exterior lighting (6) Stadium roof lights (2) Header Lights (2) Under-cab after-cut (stubble) lights (1) Grain tank, (1) unload auger tube and (2) rear worklights (4) Combination amber flashing warning/turn signal lights (2) Power outlets for optional portable service light (1) Cleaning system light (4) Under shield and (1) engine deck service lights Rotating beacons – (2) front and (1) rear
MISCELLANEOUS
Operator’s manual (English)
ENGINE AND DRIVES CX8070
New Holland ECOBlue™ Tier 4Cursor9.0L 6-cylinder diesel Full electronic fuel authority 326 SAE hp (240 kw) Power Rise 41 hp (28 kw) Maximum power 367 hp (270 kw) Air-to-air intercooler 200-gallon (750 liter) fuel tank Water separator fuel filter and fuel cooler Key switch engine shutoff ISO-mounted radiator, in-line core with pressurized deaerating tank Engine coolant filter with conditioner Coolant level sensor Water In Fuel (WIF) sensor Hinged, swing-out oil cooler and AC condenser Air filter: dual-stage, dry-type with aspirated precleaner with in-cab service indicator Engine Coolant Heater
ENGINE AND DRIVES CX8090
New Holland ECOBlue™ Tier4 Cursor9.0L 6-cylinder diesel Full electronic fuel authority 449 SAE hp (330 kw) Power Rise 40 hp (30 kw) Maximum power 489 hp (360 kw) Air-to-air intercooler 265-gallon (1000 liter) fuel tank Water separator fuel filter and fuel cooler Key switch engine shutoff ISO-mounted radiator, in-line core with pressurized deaerating tank Engine coolant filter with conditioner Coolant level sensor Water In Fuel (WIF) sensor Hinged, swing-out oil cooler and AC condenser Air filter: dual-stage, dry-type with aspirated precleaner with in-cab service indicator Engine Coolant Heater
WARRANTY
New Holland Standard Warranty AppliesOperator’s manual
MANUAL
ENGINE AND DRIVES CX8080
New Holland ECOBlue™ Tier 4 Cursor9.0L 6-cylinder diesel Full electronic fuel authority 360 CV hp (265 kw) Power Rise 41 hp (30 kw) Maximum power 401 hp (295 kw) Air-to-air intercooler 265-gallon (1000 liter) fuel tank Water separator fuel filter and fuel cooler Key switch engine shutoff ISO-mounted radiator, in-line core with pressurized deaerating tank Engine coolant filter with conditioner Coolant level sensor Water In Fuel (WIF) sensor Hinged, swing-out oil cooler and AC condenser Air filter: dual-stage, dry-type with aspirated precleaner with in-cab service indicator Engine coolant heater
(Source – http://nh.ironbuilder.com/selectModel.aspx?series_ID=684#)
Submit a Comment